Hi, I followed the guidelines and am stuck where I sopt autoboot mode, and it displays the following:
Have you managed to continue after this in order to serial flash the firm? PW4 Wifi Model, thank you.
Code:
HW
U-Boot 2016.03 (Mar 10 2020 - 03:20:17 +0000)
CPU: Freescale i.MX6SLL rev1.1 996 MHz (running at 792 MHz)
CPU: Commercial temperature grade (0C to 95C) at 41C
Reset cause: POR
Board: MX6SLL Rex
I2C: ready
DRAM: 512 MiB
entering PMIC test mode
in PMIC test mode -- apply bootup workaround
switching back to PMIC user mode
setup_pmic_mode -- make sure pmic is in user mode
MMC: FSL_SDHC: 0, FSL_SDHC: 1, FSL_SDHC: 2
idme_initialize
Idme version is 2.x and set related function to V2.x
IDME table version 2.1
hibernation: Not from hibernation
Core : f770ee83 2018/03/16 19:49:02 (Licensed to Amazon Fulfillment Services,Inc..)
SBIOS: v2.0 2022/02/01 01:29:58
TTBR:9fffc059
Platform: v2.0 2022/02/01 01:29:58
fl
*** Warning - bad CRC, using default environment
In: serial
Out: serial
Err: serial
Hardware Board: Unknown(12)
Board ID is P001F209052309TW
WFO module
secure_cpu: 1, production: 1, unlocked: 0
Boot mode is 0
Hit any key to stop autoboot: 0
Enter fastboot mode, use Ctrl+C to exit.
