Hi,
I recently aquired a PW2 where the device hangs on the boot-up screen. Having read a bit here about serial console and the possibility to unbrick it I thought that I'd have a go. Unfortunately there seem to have been someone else trying the same thing as both RX and TX pads are ripped off the PCB in the P800 serial debug square.
My question is thus; do anyone know if the test pads on the back is connected to the serial interface or is it just as good to leave the PW2 to the recycling centre?
I recently aquired a PW2 where the device hangs on the boot-up screen. Having read a bit here about serial console and the possibility to unbrick it I thought that I'd have a go. Unfortunately there seem to have been someone else trying the same thing as both RX and TX pads are ripped off the PCB in the P800 serial debug square.
My question is thus; do anyone know if the test pads on the back is connected to the serial interface or is it just as good to leave the PW2 to the recycling centre?